
- #ROYAL TSX THE CONNECTION FAILED ERROR CODE CONNECTERROR SERIAL#
- #ROYAL TSX THE CONNECTION FAILED ERROR CODE CONNECTERROR PLUS#
Using AC power while charging the battery inserted in the unit. The AC wall adaptor available for your docking station or Snap Module allows you to operate your hand-held Since the Omnii hand strap slot will still be accessible.ĪC Wall Adaptor - Models ST1050 and ST1050-AR NOTE If you are using a hand strap, there is no need to remove it before installing the Snap Module,
#ROYAL TSX THE CONNECTION FAILED ERROR CODE CONNECTERROR SERIAL#
Snap Module to the Omnii and use the Omnii battery to power USB or serial peripherals, for enhanced ThenĬonnect the charger DC plug into the Snap Module DC jack. To remove the charger, press down on the base of the clip arms to release them from the Omnii side railsĬonnect the charger to an AC or DC power source using the appropriate regional plug or cable. Into place (Refer to Figure 4-6 Snap Module Installation on page 4-6). ToĪttach the charger, align it with the base of the hand-held and gently slide up until the locking clips snap Make sure that the charger connector and the Omnii docking connector are free of dust or any other debrisĪ slot in the side rail on each side of the hand-held accommodates the locking clips of the charger. To attach the Snap Module charger to the Omnii: Omnii Hand-Held Computer with Windows CE 6.0 User Guide Ports menu, select on for the Power parameter under the COM6 port. In your Omnii desktop, go to Control Panel>Scanners, which opens the Scanner Settings menus.

Pin 9 is reserved for 5V power out and is defaulted to off. Omnii, and provides serial communications to tethered devices. Model ST4005 (Serial variant): provides a powered DE9M serial connector. When attached to the Omnii, itĪllows ActiveSync or Windows Mobile Device Center connectivity with your PC, and the use of a USBĭevice such as a USB memory key or supported peripheral. It provides communications via USBġ.1/2.0 Host and USB 2.0 Client connectors and provides a DC IN port. Model ST4001 (USB variant): powers and charges the hand-held. Model ST4000 (Charger only variant): powers and charges the hand-held. Three types of Snap Modules are available:

(Model ST1050 or ST1050-AR) and the Vehicle Power Outlet Adaptor (Model ST3113). They are compatible with the AC wall adaptor Snap Modules are mobile power chargers for the Omnii. The guide should be reviewed for additional information and updates. NOTE The Snap Modules are shipped with their own quick start guide (Omnii Snap Modules Quick Start
#ROYAL TSX THE CONNECTION FAILED ERROR CODE CONNECTERROR PLUS#
Snap Module – DE9M powered serial plus Charger Snap Module – USB Host/Client plus Charger

The following accessories can be ordered for your Omnii:
